Filter
Top Products
4
CTSLL Enclosure Installation
CTSLLG Enclosure Installation
1. Remove the lid from the battery vault.
2. Position the CTSLLG on the edge of the vault lid.
3. Install two 5/16” (.8 cm) x 1” (2.5 cm) flat head screws through the lid into the holes in the back
of the CTSLLG.
4. Install four 5/16” (.8 cm) x 3/4” (2 cm) flat head screws through the lid into the holes in the front
and sides of the CTSLLG.
5. Replace the lid with the attached enclosure, onto the vault. See diagram.
6. Upend the vault to a 90º angle, taking care that the enclosure does not fall.
7. Insert two 3” (8 cm) carriage bolts into one of the long brackets.
8. Place the bracket on the underside mounting lip on the vault lid.
9. Insert the other long bracket onto the carriage bolts and partially tighten using two flat washers
and nuts.
10. Slide the bracket upward toward the front edge of the vault lid.
11. Use the same procedure to install the two short brackets at the rear of the vault lid.
12. Lower the vault with the enclosure attached into the prepared hole. Refer to the battery vault
User Manual, 990-1220.