Filter
Top Products
User Manual version 2305
APOLLO 120/150 III
7-126
u PARALLEL PORT MODE
Select an operating mode for the onboard parallel (printer)
port. Select Normal, Compatible, or SPP unless you are
certain your hardware and software both support one of the
other available modes.
The choice: SPP, EPP, ECP, ECP+EPP.
u ECP MODE USE DMA
Select a DMA channel for the parallel port for use during ECP
mode.
The choice: 3, 1.
u USB CONTROLLER
Select Enabled if your system contains a Universal Serial Bus
(USB) controller and you have USB peripherals.
The choice: Enabled or Disabled.
u USB KEYBOARD SUPPORT
Select Enabled if your system contains a Universal Serial Bus
(USB) controller and you have a USB keyboard.
The choice: Enabled or Disabled.
u IDE HDD BLOCK MODE
Block mode is also called block transfer, multiple commands,
or multiple sector read/write. If your IDE hard drive supports
block mode (most new drives do), select Enabled for
automatic detection of the optimal number of block
read/writes per sector the drive can support.
The choice: Enabled or Disabled.
u INIT DISPLAY FIRST
This item allows you to decide to active which bus first (PCI
Slot or AGP first).
The choice: PCI Slot or, AGP.
u SYSTEM SHARE MEMORY SIZE
This item defines the System Share Memory Size for video.
The choice: 2MB, 4MB, 8MB, 16MB, 32MB, 64MB