Filter
Top Products
ViewSonic PJL855
2
Warning Following these instructions could prevent possible injury or death.
If any of events listed below
occur, switch projector OFF, pull
power plug out of power source,
and contact ViewSonic
®
Customer
Support (see back cover):
• If there is an abnormal smell or
smoke
• If suddenly there is no picture, no
sound, or an abnormal sound
• If water or any other liquid enters
the projector
To prevent possible electric
shock or fire, handle power cord
and power plug with care:
• Do not touch the power cord with
wet hands.
• TO DISCONNECT THE UNIT
FROM THE POWER SOURCE,
GRASP THE POWER PLUG, AND
PULL. DO NOT PULL THE
POWER CORD ITSELF.
• Do not damage the power cord by
pulling, bending, heating, or placing
heavy objects on it.
To prevent possible electric shock
or fire, keep liquids away from
projector:
• Do not use the projector near water
(such as a shower, sink, etc.).
• Do not put an open container with
liquid on or near the projector (such
as a vase, open beverage container,
etc.).
Do not insert a foreign object into
any part of the projector:
• To prevent electric shock or fire, do
not insert a metal or flammable object
through the ventilation holes, etc.
• If foreign matter enters the projector,
switch it OFF and pull the power plug
out of the power source.
• Prevent small children from inserting
objects into the projector.
Only use recommended power
supply:
• Do not use any power source that has
a voltage other than what this user's
guide specifies. See page 12.
Also, do not look directly into
projector lens when lamp is lit:
• Prevent all people especially small
children, from looking into the
projector lens when the lamp is lit.
Do not subject projector to
physical shock or place projector
on unstable surface:
• Do not place the projector in a
location where it is likely to be struck
or bumped into.
• Avoid placing the projector on a shelf,
cabinet, etc. that cannot adequately
support its weight, or that is on an
inclined floor.
• When the projector is placed on a
table with casters, set the caster
stoppers to prevent movement.
WARNING:
This equipment has been tested and found to comply
with the limits of a Class A digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used
in accordance with the user guide, may interfere with
radio communications.
Operation of this equipment in a residential area is
likely to cause interference in which case the user will
be required to correct the interference at his own
expense.
Instructions for FCC compliance:
This equipment complies with the requirements of FCC
(Federal Communication Commission) Class A equipment
provided that the following conditions are met:
1 Video signal cables:
Double shielded coaxial cables (so called FCC shielded
cable) must be used. The outer shield must be connected
to the ground. If normal coaxial cables are used, they must
be enclosed in metal pipes or similar material to reduce the
interference they may cause.
2 Power cord:
A shielded power cord must be used. The outer shield must
be grounded.
3 Video Inputs:
The amplitude of the input signal must not exceed the level
specified in this user's guide.
Important Safety Precautions
Caution Following these instructions could prevent personal injury or damage to the projector.
To prevent damage from heat
build-up:
• Clean the air filter after every 100
hours of operation. (See page 16.)
• Do not place the projector in direct
sunlight or near a source of heat like a
furnace, electric heater, etc.
• Do not block ventilation holes (by
placing the projector on its side, or on
a carpet, bedspread etc.)
• Place the projector at least 10cm from
any wall (allowing space for the
ventilation holes).
Do not place projector in moist or
dusty place:
• Do not place the projector in an area
containing steam (from a humidifier,
etc.) dust, or soot (from a stove, etc).
If projector will not be used for
long time, pull out power plug and
close lens cover.
Have inside of projector cleaned
at least every two (2) years :
• Contact a ViewSonic Customer
Service for information about where
to have the inside cleaned. Never
attempt to open the cabinet to clean
the inside of the projector yourself.
• To clean the lens and cabinet, follow
the instructions on page 16.
Do not place heavy objects on the
projector.
CAUTION:
To prevent possible eye damage:
•
DO NOT look directly at the laser
light from the aperture at the
front of the Remote Control
Unit. (See page 7.)
•
DO NOT point the laser light at
any person's eyes.