Filter
Top Products
ARTDio IPP 1000 Series
32
Auto-Attendant Recording Commands
1. Pick up the phone, listen for dial tone, dial ##9999 after hearing confirmation response of two
beeps:
2. Record greeting 1, dial 991* Æ begin recording, dial # Æ when recording is finished
3. Save greeting 1 recording, dial 9# Æ dial # after hearing confirmation response of two beeps
4. Record greeting 2, dial 992* Æ begin recording, dial # Æ when recording is finished
5. Save greeting 2 recording, dial 9# Æ dial # after hearing confirmation response of two beeps
6. Record greeting 3, dial 993* Æ begin recording, dial # Æ when recording is finished
7. Save greeting 3 recording, dial 9# Æ dial # after hearing confirmation response of two beeps
8. Record greeting 4, dial 994* Æ begin recording, dial # Æ when recording is finished
9. Save greeting 4 recording, dial 9# Æ dial # after hearing confirmation response of two beeps
10. Record greeting 5, dial 995* Æ begin recording, dial # Æ when recording is finished
11. Save greeting 5 recording, dial 9# Æ dial # after hearing confirmation response of two beeps
5-13 Numbering Plan
NO TWO ACCESS CODES CAN HAVE IDENTICAL DIGITS! Please regard this
requirement when setting access codes. It is recommended to review set access codes when setting
or re-setting a code to avoid a conflict or malfunction.
5-14 Barring Classes
A barring class is used to specify which numbers can or cannot be dialed. Every barring class
element includes the following information: There are six barring classes on the device and all
extensions can be assigned to any class. Initially they are all unassigned and have no association
with any gateways in the group.
Class Name
The name of class
Class Attribute
The class attribute can be set to either “Deny” or “Accept”. Both attributes have a barring table
and an exception table. Each class contains only one attribute.
Attribute Meaning
DENY
Barring table:
Exception table:
Denies
all numbers except those specified in the
exception table. The barring table does not need to have
elements because “Deny” in general is used to bar all
numbers except those found in the exception table.
ACCEPT
Barring table:
Exception table:
Accepts
all numbers except the numbers listed in the
barring table. However the numbers specified in the
exception table should not be barred.