Filter
Top Products
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
4
Display Setup and On Screen Display
Connect and secure cables to the display and the computer, except for the USB cable.The AC cordset provided
with your display should be appropriate for your region.If the proper cordset has not been provided, you may use
any cordset with an IEC320 connector at the appliance end to connect to the power adapter of your touch display.
Notice: Unless your Aspen Touch Monitor has a serial data interface, or you are connecting this Touch
Monitor to a computer that already has Aspen touchscreen MSR and Customer Display drivers installed,
please leave the USB cable disconnected until the appropriate drivers for your computer’s operating system
have been installed.
You can now set up the display for operation with your computer.Display setup requires use of some of the main
features of the On Screen Display (OSD), listed below.Detailed use of the OSD is described later in this section.
On Screen Display Controls:The following table shows the OSD and Power control buttons, located on the
right side of the display, and both the Normal and Direct Access functions of these buttons.
The Direct Access features can be used by pushing the corresponding button without entering the OSD Menu
first.For example, you may access the Display Brightness feature through Direct Access by simply pushing the
Up button.
Button Symbol Button Name Normal Function Direct Access
❶ Menu Displays/Exits OSD Menu
❷ Up Increases selected item value Display brightness
❸ Down Decreases selected item value Audio ON/OFF
❹ Enter Selects highlighted menu item Video auto adjust
❺ Power Turns all display power ON/OFF
Display Setup: Use the OSD buttons to set up the display:
1. Turn on the display with the POWER button.Both the power adapter and the display have power indicator
lights.The power indicator light on the power adapter will illuminate when AC power is applied to the
adapter.The power indicator light on the display will illuminate when the display is turned on with the
POWER button.
2. The display will initially be set to properly display the native resolution for the LCD panel, which is
800 x 600 pixels. If your computer outputs a video signal at another resolution, further adjustment than
described in this section may be required.Contact Aspen Technical Support if assistance is required.
3. Press the ENTER button on the OSD controls.A pop-up window on the display should appear with the
message “Auto Adjusting Please Wait.”
4. Inspect the top, bottom, left and right edges of a typical application to make sure you can see the entire
image on the display without scrolling.If so, you are finished with the basic setup of the display.
Display Resolution:If your application requires use of the display at another resolution than 800 x 600, such as
640 x 480, you may achieve satisfactory operation by using the Auto Adjust procedure described above, or you
may need to use the individual controls in the OSD to properly adjust the display.Access the OSD main menu and
use the Video Adjustment functions (see table below) to resize, move, or adjust the quality of the displayed image.
OSD Menu and Function:The complete OSD Menu is shown in the table below.The Main Menu icon for each
menu group is shaded, and the individual functions within the group follow.To access the OSD Menu, push the
MENU button.