Filter
Top Products
2-142-14
2-142-14
2-14
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
2.3.62.3.6
2.3.62.3.6
2.3.6
Primary and Secondary IDE Master/SlavePrimary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/SlavePrimary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/Slave
Primary IDE Master [Auto]Primary IDE Master [Auto]
Primary IDE Master [Auto]Primary IDE Master [Auto]
Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this may
be because the hard disk drive is too old or too new. If the hard disk was
already formatted on an older system, Setup may detect incorrect
parameters. In these cases, select [Manual] to manually enter the IDE hard
disk drive parameters. Refer to the next section for details.
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity 20021 MB
Cylinder 38792
Head 16
Sector 63
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode None
Select Menu
Item Specific Help
Press [Enter] to
select.
Primary IDE Master
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]Access Mode [Auto]
Access Mode [Auto]
This item allows the user to select the sector addressing mode. CHS
(cylinder, head, sector) mode supports 528 MB hard disks. LBA (logical
block addressing) mode supports hard disks up to 128 GB in size. Large
mode (also called extended CHS mode) supports hard disks above 528 MB
in size, but does not support LBA mode. Configuration options: [CHS]
[LBA] [Large] [Auto]