Asus E3769 Computer Hardware User Manual


 
ASUS Crosshair II Formula
2-31
4. USB connectors (10-1 pin USB 78; USB 910; USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0

Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!

then install the Q-Connector (USB) to the USB connector onboard.
3. Floppy disk drive connector (34-1 pin FLOPPY)

one end of the cable to this connector, then connect the other end to the

Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
CROSSHAIR II FORMULA
®
RESET
FLOPPY
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
PIN1
CROSSHAIR II FORMULA Floppy disk drive connector
CROSSHAIR II FORMULA
®
RESET
PIN 1
USB+5V
USB_P8-
USB_P8+
GND
NC
USB+5V
USB_P7-
USB_P7+
GND
USB78
PIN 1
USB+5V
USB_P10-
USB_P10+
GND
NC
USB+5V
USB_P9-
USB_P9+
GND
USB910
PIN 1
USB+5V
USB_P12-
USB_P12+
GND
NC
USB+5V
USB_P11-
USB_P11+
GND
USB1112
CROSSHAIR II FORMULA USB 2.0 connectors