Filter
Top Products
2-21ASUS V-Series M2NC61P
2.10 Installingaoppydiskdrive
The V-Series M2NC61P system comes with one 3.25-inch drive bay for a oppy
disk drive.
To install a oppy disk drive:
1. Remove the drive slot metal plate cover.
2. Carefully insert the oppy disk drive into the oppy drive bay until the screw
holes align with the holes on the bay.
3. Secure the oppy disk drive with two screws on both sides.
4. Connect the oppy disk drive signal cable to the signal connector at the back
of the drive.
5. Connect the other end of the signal cable to the oppy disk drive connector
on the motherboard. See page 4-5 for the location of the oppy disk drive
connector.
6. Connect a 4-pin power cable from the power supply unit to the power connector
at the back of the oppy disk drive.
Floppy ribbon cable
Power cable
3
3
2
3
3
2
remove the metal
plate cover and
install the card
reader module here