Filter
Top Products
ASUS P2Z-VM User’s Manual 53
IV. BIOS SETUP
IV. BIOS SETUP
Power Management
PWR Up On Modem Act (Enabled)
This allows either settings of Enabled or Disabled for powering up the computer (turns the
ATX power supply on) when the modem receives a call while the computer is Soft-off.
NOTE: The computer cannot receive or transmit data until the computer and appli-
cations are fully running, thus connection cannot be made on the first try. Turning an
external modem off and then back on while the computer is off causes an initialization
string that will also cause the system to power on.
AC PWR Loss Restart (Disabled)
This allows you to set whether you want your system to boot up after the power has
been interrupted. Disabled leaves your system off after reapplying power and En-
abled boots up your system after reapplying power.
Power Up By Keyboard (Disabled)
This allows the computer to be powered on by pressing any key on the keyboard. Set
of Enabled to set this feature. WARNING: This setting must coincide with the key-
board power up jumper setting or else conflicts will occur.
Wake On LAN (Disabled)
This allows you to remotely power up your system through your network by sending
a wake-up frame or signal. With this feature, you can remotely upload/download
data to/from systems during off-peak hours. Enabled sets this feature.
IMPORTANT: This feature requires the optional network interface and an ATX power
supply with at least 720mA +5V standby power.
Automatic Power Up (Disabled)
This allows you to have an unattended or automatic power up of your system. You may
configure your system to power up at a certain time of the day by selecting Everyday,
which will allow you to set the time or at a certain time and day by selecting By Date.