Filter
Top Products
1-16
Chapter 1: Product introduction
1.10.2 Internal connectors
1. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
This connector supports the provided Ultra DMA 100/66 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the primary (recommended) or
secondary IDE connector, then connect the gray connector to the Ultra DMA
100/66 slave device (hard disk drive) and the black connector to the Ultra DMA
100/66 master device.
2. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
• Follow the hard disk drive documentation when setting the device in master
or slave mode.
• Pin 20 on each IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect orientation when you
connect the cables.
• The hole near the blue connector on the Ultra DMA cable is intentional.
P4GE-MX IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1
PRI_IDE
®
P4GE-MX
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4GE-MX Floppy disk drive connector
PIN 1
FLOPPY1
®
P4GE-MX