Filter
Top Products
2-16
Chapter 2: BIOS information
DRAM RAS# to CAS# Delay [3]
Sets the latency between the DRAM active command and the R/W command.
Configuration options: [3] [2]
DRAM RAS# Precharge [3]
Sets the idle clocks after issuing a precharge command to the DRAM.
Configuration options: [3] [2]
Memory Frequency for [Auto]
This item allows you set the FSB and system memory frequency. The default
setting is [Auto]. Configuration options: [PC100] [PC133] [Auto]
AGP Aperture Size (MB) [64]
Sets the size of the AGP aperture.
Configuration options: [4] [8] [16] [32] [64] [128] [256]
On-Chip Frame Buffer Size [8MB]
Sets the frame buffer size. Configuration options: [1MB] [8MB]
Init Display First [PCI Slot]
Selects which graphics controller to use as the primary boot device.
Configuration options: [PCI slot] [Onboard] [AGP]
Hyper-Threading Technology [Enabled]
Enables or disables the Intel® Hyper-Threading Technology feature.
Configuration options: [Disabled] [Enabled]
CPU Clock Ratio [8 X]
Allows you to key-in the ratio between the CPU core clock and the Front Side Bus
(FSB) frequency. To do so, highlight the item then press <Enter> to display a
pop-up menu. Enter a value from the specified range, then press Enter. The
configuration option values depend on the CPU installed.
Auto Detect PCI Clk [Enabled]
Allows you to disable or enable the auto-detect function of the PCI clock. When
enabled, the bus speed is calculated based on the capacity of the device installed.
CPU Clock [100MHz]
This item allows you to set the CPU frequency. To do so, highlight the item then
press <Enter> to display a pop-up menu. Enter a value from the specified range,
then press Enter. The configuration option values depend on the CPU installed.