Asus P5GC-MX Network Card User Manual


 
2-6 Chapter 2: BIOS setup
2.1.4 ASUS CrashFree BIOS 2 u tility
The ASUS CrashFree BIOS 2 is an auto recovery tool that allows you to
restore the BIOS le when it fails or gets corrupted during the updating
process. You can update a corrupted BIOS le using the motherboard
support CD, or the oppy disk that contains the updated BIOS le.
Prepare the motherboard support CD, or the oppy disk containing
the updated motherboard BIOS before using this utility.
Make sure that you rename the original or updated BIOS le in the
oppy disk to P5GCMX.ROM.
Recovering the BIOS from a floppy disk
To recover the BIOS from a oppy disk:
1. Turn on the system.
2. Insert the oppy disk with the original or updated BIOS le to the
oppy disk drive.
3. The utility displays the following message and automatically checks
the oppy disk for the original or updated BIOS le.
Bad BIOS checksum. Starting BIOS recovery...
Checking for oppy...
4. Restart the system after the utility completes the updating process.
Bad BIOS checksum. Starting BIOS recovery...
Checking for oppy...
Floppy found!
Reading le “P5GCMX.ROM”. Completed.
Start ashing...
When found, the utility reads the BIOS le and starts ashing the
corrupted BIOS le.
DO NOT shut down or reset the system while updating the BIOS! Doing
so can cause system boot failure!
If your display monitor is connected to the onboard VGA connector, the
display monitor will turn-off and the system will beep once while the
CrashFree BIOS 2 starts updating your system. The system will beep
once again while the process is nished, and the display will return after
the system restarts.