Asus P5N64 WS Computer Hardware User Manual


  Open as PDF
of 188
 
5-54 Chapter 5: Software support
5.4.4 Marvell
®
SAS RAID congurations
The Marvell
®
88SE6320 SAS controller allows you to congure RAID 0, RAID 1,
and RAID 10 set(s) on the SAS hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set.
To do this:
1. Install two internal SAS hard disk drives to the SAS connectors labeled
SAS1/2
.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
3. In the
Advanced
menu, go to
Onboard Devices Conguration
, and enable
both
Marvell 6320/SAS
and
6320 Boot ROM
.
4. Press <F10> to save the changes and exit.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Device Conguraiton
High Denition Audio [Enabled]
OnChip LAN1 [Auto]
OnChip LAN2 [Auto]
LAN Boot ROM [Disabled]
Marvell 6121/eSATA [Legacy Mode]
6121 Boot ROM [Enabled]
Marvell 6320/SAS [Enabled]
6320 Boot ROM [Enabled]
Onboard 1394 [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Denition Audio
Controller
BIOS SETUP UTILITY
Advanced
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
 previous next