Filter
Top Products
2-282-28
2-282-28
2-28
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setupChapter 2: BIOS setup
Chapter 2: BIOS setup
2.5.52.5.5
2.5.52.5.5
2.5.5
APM ConfigurationAPM Configuration
APM ConfigurationAPM Configuration
APM Configuration
APM Configuration
Power Management/APM [Enabled]
Restore on AC Power Loss [Power Off]
Resume On Ring [Disabled]
Resume On PME# [Disabled]
Resume On PS/2 Keyboard [Disabled]
Resume On PS/2 Mouse [Disabled]
Resume On RTC Alarm [Disabled]
Power Management/APM [Enabled]Power Management/APM [Enabled]
Power Management/APM [Enabled]Power Management/APM [Enabled]
Power Management/APM [Enabled]
Allows you to enable or disable the advanced power management feature.
Configuration options: [Disabled] [Enabled]
Restore on AC Power Loss [Power Off]Restore on AC Power Loss [Power Off]
Restore on AC Power Loss [Power Off]Restore on AC Power Loss [Power Off]
Restore on AC Power Loss [Power Off]
When set to Power Off, the system goes into off state after an AC power
loss. When set to Power On, the system goes on after an AC power loss.
When set to Last State, the system goes into either off or on state,
whatever the system state was before the AC power loss.
Configuration options: [Power OFF] [Power On] [Last State]
Resume On Ring [Disabled]Resume On Ring [Disabled]
Resume On Ring [Disabled]Resume On Ring [Disabled]
Resume On Ring [Disabled]
When set to [Enabled], the system enables the RI to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On PME# [Disabled]Resume On PME# [Disabled]
Resume On PME# [Disabled]Resume On PME# [Disabled]
Resume On PME# [Disabled]
When set to [Enabled], the system enables the PME to generate a wake
event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On PS/2 Keyboard [Disabled]Resume On PS/2 Keyboard [Disabled]
Resume On PS/2 Keyboard [Disabled]Resume On PS/2 Keyboard [Disabled]
Resume On PS/2 Keyboard [Disabled]
Allows you to disable the PS/2 Power-On by keyboard feature or use
specific keys on the keyboard to turn on the system. This feature requires
an ATX power supply that provides at least 1A on the +5VSB lead.
Configuration options: [Disabled] [Enabled]
Resume On PS/2 Mouse [Disabled]Resume On PS/2 Mouse [Disabled]
Resume On PS/2 Mouse [Disabled]Resume On PS/2 Mouse [Disabled]
Resume On PS/2 Mouse [Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 mouse
to turn on the system. This feature requires an ATX power supply that
provides at least 1A on the +5VSB lead. Configuration options: [Disabled]
[Enabled]