Filter
Top Products
2-34 Chapter 2: Hardware information
Important notes on Serial ATA
•
You must install Windows
®
2000 Service Pack 4 or the Windows
®
XP
Service Pack 1 before using Serial ATA hard disk drives. The Serial
ATA RAID feature (RAID 0/RAID 1/RAID 5/RAID 10) is available only
if you are using Windows
®
2000/XP/Server 2003 or later version.
•
When using the connectors in Standard IDE mode, connect the
primary (boot) hard disk drive to the SATA1 or SATA2 connector.
Refer to the table below for the recommended SATA hard disk drive
connections.
Serial ATA hard disk drive connection
Connector Color Setting Use
SATA1/SATA2 Red Master Boot disk
SATA3/SATA4 Black Slave Data disk
4. Marvell
®
88SE614x
Serial ATA connectors
(7-pin EXT_SATA1, EXT_SATA2, EXT_SATA3)
These connectors are for Serial ATA signal cables. These connectors
support Serial ATA hard disk drives.
Set the Marvell SATA Controller and Marvell SATA BOOTROM items in
the BIOS to [Enabled] to use the connectors to build a RAID set. See
section “4.4.6 Onboard Devices Conguration” for details.
Before creating a RAID set using Serial ATA hard disks, make sure that
you have connected the Serial ATA signal cables and installed Serial ATA
hard disk drives; otherwise, you cannot enter the Marvell
®
88SE6141
RAID utility.
P5WDG2-WS PRO
®
P5WDG2-WS PRO SATA 3 Gbps connector
EXT_SATA3 EXT_SATA2 EXT_SATA1
GND
RSATA_TX_0_DP
RSATA_TX_0_DN
GND
RSATA_RX_0_DN
RSATA_RX_0_DP
GND
GND
RSATA_TX_1_DP
RSATA_TX_1_DN
GND
RSATA_RX_1_DN
RSATA_RX_1_DP
GND
GND
RSATA_TX_2_DP
RSATA_TX_2_DN
GND
RSATA_RX_2_DN
RSATA_RX_2_DP
GND