Filter
Top Products
6-4 Chapter 6: RAID conguration
6.2 Intel
®
Rapid Storage Technology
enterprise SATA Option ROM Utility
The Intel
®
Rapid Storage Technology enterprise SATA Option ROM utility allows
you to create
RAID 0, RAID 1, RAID 10 (RAID 1+0), and RAID 5 set(s) from Serial ATA hard
disk drives that are connected to the Serial ATA connectors supported by the
Southbridge.
The navigation keys at the bottom of the screen allow you to move through the
menus and select the menu options.
The RAID BIOS setup screens shown in this section are for reference only and
may not exactly match the items on your screen.
To launch the Intel
®
Rapid Storage Technology enterprise SATA Option ROM utility:
1. Turn on the system.
2. During POST, press <Ctrl>+<I> to display the utility main menu.
Before you proceed, ensure that you have installed the Serial ATA hard disk
drives, have set the correct jumper settings of the motherboard, and have
set the correct SATA mode in the BIOS setup. You can refer to sections
5.1.2
Installing hard disk drives
,
5.1.3 Setting Jumpers
, and
5.1.4 Setting the
RAID mode in BIOS
for more information.
[ESC]-Exit [ENTER]-Select Menu[ ]-Select
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 3.6.0.1023
Copyright(C) 2003-12 Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION]
RAID Volumes:
None defined.
Physical Disks:
ID Drive Model Serial # Size Type/Status(Vol ID)
0 ST3300656SS HWAS0000991753TR 279.3GB Non-RAID Disk
1 ST3300656SS 37VN00009846RAJ1 279.3GB Non-RAID Disk
2 ST3300656SS 397600009846UEDY 279.3GB Non-RAID Disk
3 ST3300656SS GWC50000991756G6 279.3GB Non-RAID Disk
3. Reset Disks to Non-RAID
4. Exit
1. Create RAID Volume
2. Delete RAID Volume