Filter
Top Products
85
5. SOFTWARE SETUP
ASUS TUSL2 User’s Manual
5. S/W SETUP
5.4.1 Installing the Hard Disks
The RAID 0 setting allows users to reformat two hard disks with the same new OS
simultaneously. RAID 1 arrays can use a pre-existing hard disk along with a blank
hard disk, or two new hard disks.
1. Install the first and second hard disk into the hard disk bays of your system.
Connect each hard disk drive with a separate UltraDMA/100 cable, one to the
Primary ATA IDE1 connector, and the other to the Secondary ATA IDE2 connector
onboard the TUSL2.
2. Connect the power cables to the hard disks.
3. Ensure that the ATA/100 / RAID 0/1 jumper 3 is reset from the default to [1-2].
(See: Section 3.4.2, Hardware Setup: Motherboard Settings)
4. Boot-up the PC.
RAID
FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.
Auto Setup . . . . . . . . . . [ 1 ]
[ 1 ]
View Drive Assignments . . . . [ 2 ]
[ 2 ]
View Array . . . . . . . . . . [ 3 ]
[ 3 ]
Delete Array . . . . . . . . . [ 4 ]
[ 4 ]
Rebuild Array. . . . . . . . . [ 5 ]
[ 5 ]
Controller Configuration . . . [ 6 ]
[ 6 ]
Press 1..6 to select Option [ESC] Exit
[ Main Menu ]
[ Keys Available ]
2. Press <Ctrl-F> keys to display the FastBuild™ Utility Main Menu:
5.4.2 Enter FastTrak100 BIOS and FastBuild Utility
1. If this is the first time you have booted with two hard disks correctly installed,
then FastTrak100™ “Lite” BIOS scans the IDE drives and displays this
screen: