Asus TX97-LE Personal Computer User Manual


  Open as PDF
of 64
 
ASUS TX97-LE User’s Manual 13
III. INSTALLATION
Jumpers
1) BBLKW p. 15 Flash ROM Boot Block Program (Disable/Enable)
2) CLRTC p. 15 Real Time Clock RAM (Clear Data)
3) KBPWR p. 16 Keyboard Power Up (Enable/Disable)
4) FS0, FS1, FS2 p. 16 CPU External Clock (BUS) Frequency Selection
5) BF0, BF1, BF2 p. 16 CPU:BUS Frequency Ratio
6) VID0, VID1, VID2 p. 18 CPU Voltage Selection
Expansion Slots
1) SIMM Sockets p. 19 72-Pin SIMM Memory Expansion Sockets
2) DIMM Sockets p. 19 168-Pin DIMM Memory Expansion Sockets
3) CPU ZIF Socket 7 p. 22 Central Processing Unit (CPU) Socket
4) SLOT 1, 2, 3 p. 23 16-bit ISA Bus Expansion Slots
*
5) PCI 1, 2, 3, 4 p. 23 32-bit PCI Bus Expansion Slots
Connectors
1) KBCON p. 25 Keyboard Connector (5-pin Female)
2) FLOPPY p. 25 Floppy Drive Connector (34-1pin Block)
3) PRINTER p. 26 Parallel (Printer) Port Connector (26-1pin Block)
4) COM1, COM2 p. 26 Serial Port COM1 & COM2 (10-1pin Blocks)
5) FAN p. 27 Power Supply, Chassis, CPU Fan Power Leads
6) CHASSIS p. 27 Chassis Open Alarm Lead (4-1pin Block)
7) Primary / Second IDE p. 28 Primary / Secondary IDE Connector (40-1pin Blocks)
8) IDELED p. 28 IDE LED Activity Light
9) ATX POWER p. 29 ATX Motherboard Power Connector (20-pin Block)
10) AT POWER p. 29 AT Motherboard Power Connector (12-pin Block)
11) PS2MOUSE/USB/IR p. 31 PS/2 Mouse/USB/IR Combo-Connector (18-1pin Block)
12) IR p. 31 Second Infrared Port Module Connector (5-pin Block)
13) MSG.LED (PANEL) p. 31 System Message LED (2 pins)
14) SMI (PANEL) p. 31 SMI Switch Lead (2 pins)
15) PWR SW. (PANEL) p. 31 ATX Power & Soft-Off Switch Lead (2 pins)
16) RESET (PANEL) p. 31 Reset Switch Lead (2 pins)
17)
PWR.LED (
PANEL
)
p. 31 System Power LED Lead (3 pins)
18)
KEYLOCK (
PANEL
)
p. 31 Keyboard Lock Switch Lead (2 pins)
19) SPEAKER (PANEL) p. 31 Speaker Output Connector (4 pins)
20) W0L_CON p. 32 Wake on LAN Activity Connector (3-pins)
*
The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address or else conflicts will occur.
(Map of Board)
III. INSTALLATION
 previous next