Filter
Top Products
ASUS TX97-LE User’s Manual48
IV. BIOS SOFTWARE
AC PWR Loss Restart (Disabled)
This allows you to set whether you want your system to boot up after the power has
been interrupted. Disabled leaves your system off after reapplying power and En-
abled boots up your system after reapplying power.
Automatic Power Up (Disabled)
This allows you to have an unattended or automatic power up of your system. You
may configure your system to power up at a certain time of the day by selecting Every-
day, which will allow you to set the time or at a certain time and day by selecting By
Date.
.....................................................................................................................................
Fan Monitor (xxxxRPM)
The onboard hardware monitor is able to detect the Chassis Fan Speed, CPU Fan
Speed, and the Power Supply Fan Speed in Rotations Per Minute (RPM). These
values refresh upon any key entries in the BIOS setup screen. Set to Ignore if one of
these are not used so that error messages will not be given.
Thermal Monitor (xxxC/xxxF)
The onboard hardware monitor is able to detect the CPU and MB (motherboard) tem-
peratures. These values refresh upon key entries. Set to Ignore only if necessary.
Voltage Monitor (xx.xV)
The onboard hardware monitor is able to detect the voltages put out by the voltage
regulators. These values refresh upon key entries. Set to Ignore only if necessary.
NOTE: If any of the monitored items are out of range, an error message will appear:
“Hardware Monitor found an error, enter POWER MANAGEMENT SETUP for
details”. You will then be prompted to “Press F1 to continue, DEL to enter SETUP”.
PNP and PCI Setup
This “PNP and PCI Setup” option configures the PCI bus slots. All PCI bus slots on
the system use INTA#, thus all installed PCI cards must be set to this value.
IV. BIOS
(PnP / PCI)