Filter
Top Products
WebShare 141W
A02-RA141-W54 Pag. 44
Select Obtain an IP Address Automatically if you have a
dynamic IP address; otherwise select Static IP Address and
type your ISP assigned IP address in the IP Address field below.
Multiplex
Select the method of multiplexing used by your ISP from the
drop-down list. Choices are VC or LLC.
Connection Settings
Always ON
Select Always ON Connection when you want your connection
up all the time. The ADSL Router will try to bring up the
connection automatically if it is disconnected.
Connect on
Demand
Connect on demand is dependent on the traffic. If there is no
traffic (or Idle) for a pre-specified period of time), the connenct
will tear down automatically. And once there is traffic send or
receive, the connection will be automatically on. Please insert
the Idle Time in minute.
IP Address
Get IP Address
The IP address can be either dynamically (via DHCP) or given
IP address provide by your ISP. For Static IP, you need to
specify the IP address, Subnet Mask and Gateway IP address.
IP Address
You must specify a Router IP address.
IP Subnet Mask
Enter a subnet mask in dotted decimal notation.
Refer to the Subnetting appendix in the to calculate a subnet
mask If you are implementing subnetting.
Gateway
You must specify a gateway IP address.
NAT
Select this option to Activate/Deactivated the NAT (Network
Address Translation) function for this VC. The NAT function can
be activated or deactivated per PVC basis.
Default Route
if enable this function, the current PVC will be the default
gateway to internet from this device.
Dynamic Route
RIP (Routing Information protocol) Select this option to specify
the RIP version, including RIP-1, RIP-2M and RIP-2B. RIP-2M
and RIP-2B are both sent in RIP-2 format; the difference is that
RIP-2M using Multicast and RIP-2 using Broadcast format.
Direction
RIP Direction Select this option to specify the RIP direction.
None is for disabling the RIP function. Both means the ADSL
Router will periodically send routing information and accetp
routing information then incorporate into routing table. IN only
means the ADLS router will only accept but will not send RIP
packet. OUT olny means the ADLS router will only send but will
not accept RIP packet.
Multicast
IGMP (Internet Group Multicast Protocol) is a session-layer
protocol used to establish membership in a multicast group. The
ADSL ATU-R supports both IGMP version 1 (IGMP-v1) and