Filter
Top Products
WEBSHARE 242W
36
3.6.3.3 System
There are six items within the System section: Time Zone, Remote Access, Firmware
Upgrade, Backup/Restore, Restart and User Management.
3.6.3.3.1 Time Zone
The router does not have a real time clock on board; instead, it uses the Simple Network
Time Protocol (SNTP) to get the current time from an SNTP server outside your network.
Choose your local time zone, click Enable and click the Apply button. After a successful
connection to the Internet, the router retrieves the correct local time from the SNTP server
you have specified. If you prefer to specify an SNTP server other than those in the drop-
down list, simply enter its IP address as shown above. Your ISP may provide an SNTP
server for you to use.
Resync Period (in minutes) is the periodic interval the router waits before it resynchronizes
the router’s time with that of the specified SNTP server. To avoid unnecessarily increasing
the load on your specified SNTP server you should keep the poll interval as high as possible
at the absolute minimum every few hours or even days.
3.6.3.3.2 Remote Access
To temporarily permit remote administration of the router (i.e. from outside your LAN), select
a time period the router permits remote access for and click Enable. You may change other
configuration options for the web administration interface using Device Management options
in the Advanced section of the GUI.