Atlantis Land i I-Fly Wireless Access Point Network Card User Manual


 
1.3 I-Fly Wireless Access Point Features
I-Fly Wireless Access Point provides the following features:
Interoperable with IEEE802.11g and IEEE802.11b
Atheros Super G™ capabilities to deliver 108 Mbps raw data rates and 90 Mbps TCP/IP
throughput for 802.11g wireless LANs (Real-time hardware data compression, Dynamic
transmit and modulation optimization and Standards-compliant bursting mode adapts to the
network)
WPA (with PSK, TKIP): The chipsets fully support Wi-Fi Protected Access (WPA) and the
IEEE 802.11i draft security standards in hardware and high-speed encryption engines for both
the Temporal Key Integrity Protocol (TKIP) and the Advanced Encryption Standard (AES)
with no performance degradation.
1 Fast Ethernet port: Support automatic switching between MDI and MDI-X for 10Base-T
and 100Base-TX ports is supported. An Ethernet straight or cross-over cable can be used
directly, this fast Ethernet switch will detect it automatically.
External Antenna: Dipole External removable Antenna (SMA)
Quick Installation Wizard: Supports a WEB GUI page to install this device quickly. With
this wizard, an end user can enter the information easily which they from the ISP, then surf the
Internet immediately.
MAC Filtering: MAC Filter function controls the MAC of the network devices that are listed
in this table for access authorization or denial.
Dynamic Host Control Protocol (DHCP) client and server: In the WAN site, the DHCP
client can get an IP address from the Internet Server Provider (ISP) automatically. In the LAN
site, the DHCP server can allocate up to 253 client IP addresses and distribute them including
IP address, subnet mask as well as DNS IP address to local computers. It provides an easy way
to manage the local IP network.
Web based GUI: supports web based GUI for configuration and management. It is user-
friendly with an on-line help, providing necessary information and assist user timing. It also
supports remote management capability for remote users to configure and manage this product.
Firmware Upgradeable: the device can be upgraded to the latest firmware through the WEB
based GUI.
1.4 System Requirements
Microsoft Internet Explorer 5.5 or higher
DSL/ Cable Modem Broadband Internet connection and ISP account
PCs equipped with 10Mbps or 10/100 Mbps Ethernet connection to support TCP/IP protocol
One CD-ROM drive
1.5 I-Fly Wireless Access Point Application
Home SOHO networking for device sharing and wireless multimedia
Wireless office provides a wider range for home and SOHO Ethernet
Enables wireless building-to-building data communication
Built-in infrastructure mode
AP provides ideal solution for:
Difficult-to-wire environments
Temporary LANs for scenarios such as trade-exhibitions and meetings
Enables LAN adaptability to frequently changing environments