Filter
Top Products
8/16/32 PS/2 KVM over IP switch
46
IP auto configuration
With this option you can control if the PS/2 IP-KVM switch should fetch its network
settings from a DHCP or BOOTP server. For DHCP, select “dhcp” , and for BOOTP
select “bootp” accordingly. If you choose“none” then IP auto configuration is disabled.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the PS/2 IP-KVM switch should be accessible from networks other than the local
one, this IP address must be set to the local network router's IP address.
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option may be left
empty, however the PS/2 IP-KVM switch will not be able to perform name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be used in case
the Primary DNS Server cannot be contacted.
Remote Console And HTTPS port
Port number at which the PS/2 IP-KVM switch's Remote Console server and HTTPS
server are listening. If left empty the default value will be used.
HTTP port
Port number at which the PS/2 IP-KVM switch's HTTP server is listening. If left empty the
default value will be used.
Telnet port
Port number at which the PS/2 IP-KVM switch's Telnet server is listening. If left empty the
default value will be used.
Bandwidth limitation
The maximum network traffic generated through the PS/2 IP-KVM switch ethernet device.
Value in Kbit/s.
Disable Enterprise Mangement
With this option you may exclude the PS/2 IP-KVM switch from management by your
supplier .
Disable Setup Protocol
Enable this option to exclude the PS/2 IP-KVM switch from the setup protocol.