Filter
Top Products
PJWU-101B 17/10/2014
59
12.Control
12.2 Eco Network Power
The projector can be connected to a network via its RS-232 port and 10/100 BASE-T port for remote operation with two
separate boards to control the signal sources from RS-232 and 10/100BASE-T ports.
If you do not require remote operation of the projector over a network, it is recommended that you set this function to On to
activate the ECO Network Power. This will turn off the power that is used to control the 10/100 BASE-T board. However, you
will not be able to operate the projector remotely over a network as long as the function remains activated.
By setting it to Off, the function will be disabled. You won’t be able to conserve power but you can control the projector
remotely over a network.
12.3 Network
To control the projector via network, after connecting the network cables for a PC and the projector, you can use this OSD
function to view the relevant network information (such as IP Address, Subnet Mask, Gateway and DHCP) of the projector.
Please configure the PC to be connected to the projector with a proper IP address with the same subnet mask, gateway as the
projector. The default IP address of the projector is 192.168.0.100. The network settings of the projector can only be changed
through the web-page control or projector Toolset application.
To control the projector via network, please connect to the projector via a web browser with the IP address shown on the
Advanced menu CONTROL —> Network. The home page will be displayed as follows.