Filter
Top Products
BlendPRO-II • User’s Guide 17
2. Hardware Orientation
BlendPRO-II Rear Panel
_äÉåÇmolJff=oÉ~ê=m~åÉä
The figure below illustrates the BlendPRO-II rear panel:
Figure 2-1. BlendPRO-II Rear Panel
Following are descriptions of each rear panel connector and section:
1) Genlock In
One BNC connector is provided for a Genlock Input, which can be used to lock
BlendPRO-II and its associated ScreenPro-II inputs to an external source if
desired. Please note:
~ BlendPRO-II can genlock to Composite bi or tri-level syncs.
~ Similarly, black burst type syncs can be used within the limitations of the
BlendPRO-II input resolutions.
~ Because BlendPRO-II does not contain a loop-through connector, the
incoming sync will be terminated to 75 Ohms.
2) Widescreen Lock Out
One BNC connector is provided for a Widescreen Lock Output, which is
required to supply H and V sync locking information to each ScreenPro-II
GENLOCK input, as well as communicate various widescreen synchronization
commands via a proprietary interface.
SERIAL
ETHERNET
100-240 V 50-60 Hz
2.3 A
INPUTS
1234
OUTPUTS
1234
1234
GENLOCK WIDESCREEN LOCK
IN OUT
6
1
5
2 3 4
7
1) Genlock In 5) Inputs Section
2) Widescreen Lock Out 6) Outputs Section
3) Serial Port 7) Ethernet Port
4) AC Connector
Important
This connector is not a loop-through, and can only be used
with BlendPRO-II and ScreenPRO-II systems.