Filter
Top Products
User manual MFGD 2320 9
2.3. Portrait or landscape position
You can change the orientation of the panel at any time, but it is more
convenient to select landscape or portrait orientation before connecting
the cables.
To change the panel orientation:
1 Stand at the front side of the panel and take the panel at both sides.
2 Very important: Tilt the panel before changing the orientation.
Should you change the panel orientation without tilting it first, you
might irreversibly damage the tilt & swivel mechanism.
3 To change from portrait to landscape, turn the panel
counterclockwise while tilting it slightly.
To change from landscape to portrait, turn clockwise.
2.4. Connecting the signals
To get access to the connectors, open the cover of the connector
compartment by pulling down the 2 clips of the cover.
The signal cables can be routed inside the display foot. Therefore,
remove the foot cover before connecting the signals (see "Before
installing the display").
Important:
Do not connect video and sync signals to the BNC and D15 connec-
tors at the same time.
To connect DVI signals:
1 Connect one end of the DVI cable to the DVI input (5) of the display.
2 Connect the other end of the DVI cable to the video output of your
DVI signal source.
3 Route the cable so that it enters the connector compartment at the
place where the cover is bulged.