Barco NW-12 Projector User Manual


 
2. PMP kit
2. PMP KIT
2.1 Introduction
Introduction
In case of failure of a PMP, it must be replaced by a (blank) new one. However, since most of the projector related data is stored
on this boa rd, this data will be lost while replacing the board. This includes not only key data such as Projector Device Type and
Projector Serial Number, but also the full set of factory se ttings of the projector w hich are indispensable to get a good quality image:
uniformity, co lors, g ray levels, etc. Not having this factory settings will denitely resu lt in a POOR QUALITY IMAGE.
To avoid loss of data, it isamustto make a backup of all the settings u sing the software tool Projector Support. This tool makes
it possible to make a full backup, including P rojector Device Type, P rojector Serial Number and Runtimes and full factory settings.
When restoring the (original!) backup on a (blank!) PMP, it will be fully c ongured in the way it was by the time of the backup.
In the situation where no backup is available and the PMP is not working properly, try to conne
ct to the projector via E thernet anyway
and use the Projector Support tool to m ake a backup. Most probably, this will be successful. If not, you will have to contact Barc o.
The Projector Support tool can be found on TDE on BarcoZone ( http://kuu net.barco.com/bgs/global/TDE2/ ):
search for Software, using string “Projector Support”)
2.2 Kit description
Scope
Two different kits are available. The table below points out wh
ich one to use.
Kit number Projector type Projector article number
Galax y NH-12
R9040400
NH-12 R9010610
iD LH-12 R9010620
R7649672K
iCon NH-12
R9010600
Galaxy NW-12
R9040410
R7649676K
NW-12 R9010700
Kit content
The kit contains a blank PMP.
2.3 Kit installation (overview)
Overview of the kit installation
1. Use Projector Support tool and mak
e a backup of the s ettings of the P MP to be replaced
2. Replace the faulty PMP by the new one of the kit
3. Restore the backup
4. Upgrade the projector to the desired s oftware version
R59770498 PMP KIT 28/02/2011
5