Barco R9001390 Projector User Manual


 
3-1
Location and Functions of Control
5975938 BARCOREALITY 9200TCR+ 020798
3
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - ST ANDBY
COMMUNICA TION PORT
(800- PERIPHERALS)
RS232 OUT
IR-ACK NOWLEDGED
IR-RECEIVED
DIAGNOSTICS
CODE
IR -RECEI VER
0
I
This device com plies with Part 15 of the FCC rules. Operation
is subject to following two cond itions :
(1) This device ma y not cause harm ful interference
(2) This device mu st accept any interferenc e received
including interference that m ay cause undes ired ope ration
SDI IN SDI OUT
LOCATION AND FUNCTIONS OF CONTROL
Front Panel Terminology
IR-Received : IR signals are received but not recognized
by the projector.
Diagnostics code : a) source number
b) error code : a two digit error code is displayed when
something goes wrong inside the projector.
IR receiver : receiver for control signals transmitted from
the RCU.
Power switch : '1' = on, '0' = off
Power input : autoranging from 200 to 240 Vac.
Identification plate : name, serial number, art. number.
Voltage identification plate : name, art. number.
1
2
3
RS232 IN : to allow communication with external compu-
ter, e.g. IBM PC or compatible, Macintosh ...
RS232 OUT : used to connect to next projector, RS232IN
plug (communication link for PC or MAC to the next
projector).
Communication port : allows communication with the
800 peripherals.
Remote : remote input for wired remote control.
Projector mode indication : indicates the status of the
projector.
Light off : power switch is not pressed.
Red light : power switch is pressed, projector in
stand by mode.
Green light : projector in operational mode.
IR-Acknowledged : IR signals are recognized.
4
5
Control Panel Terminology
a. Local keypad
Gaining access
6
7
8
9
10
11
12
The keypad is located behind a door, screened with the name
of the projector.
To open the door, push once on the indicated side of the door
and turn it to the front side of the projector.
13
SDI IN - SDI OUT (option): Serial digital input and loop trough
output.
2 x BNC terminals.