Filter
Top Products
Service Mode
7-25975039 BARCOVISION 508 120198
Projector Set-up
Highlight 'Projector Set-Up' by pushing the
control disc up or down and press ENTER
to display the projector set-up menu.
Within the projector set-up menu, the fol-
lowing items can be consultated or set to
the desired setting :
- Identification
- Total run time
- Change password
- Change projector address
- Change baudrate
- Power up mode
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
Highlight 'Identification' with the control disc and press ENTER.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
Identification
Proj. address : 001
Soft. Version : 6.00
Config. :Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
VISION 508
The 'Identification' screen gives information concerning :
- Projector address. To change the address of your projector,
contact a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or
compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is
a difference, contact a qualified service technician to make the
appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator
will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the
RCU.
- Serial no. : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
ENTER will start the selected item.
EXIT returns to the Service mode menu.