Filter
Top Products
Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
The procedure for installing
a CompactFlash™ card into the UNO-2170
is detailed below,
please
follow these steps
carefully.
1.
Remove the
power cord.
2.
Unscrew the four
screws from
the
rear panel
of the UNO-2170.
3.
Remove the
rear panel.
4.
Plug
a CompactFlash™ card
with
your
OS and application program
into a CompactFlash™ card slot
on board.
5.
Screw
back the rear
panel with four screws.
Note
The CompactFlash™ slot
is allocated as
“
Secondary IDE Master
＂
3.2 Chassis Grounding
The aluminum made UNO-2170 provides good EMI protection and a stable
grounding base.
There is
an
easy-to-connect
chassis grounding point for
you to use.
Please connect
chassis ground of
UNO-2170 with "EARTH" as ground.
Figure 3.1:
Chassis Grounding Connection
UNO-2170 User Manual 18