Filter
Top Products
17
5. The “Found New Hardware Wizard” will indicate that the
drivers for the USB Direct Connect have been located.
Click “Next”.
6. The “Found New Hardware Wizard” will now tell you that
Windows has finished installing the software for this
device. Click “Finish”.
The Direct Connect hardware is now installed. The next
section outlines how to set up the Direct Connect in the
network environment.
Adding Your Direct Connect to the System
1. Select “Start”, then “Control Panel”. Locate the
“Add/Remove Hardware” icon and double-click on
the icon.
8. Windows 2000 Instructions (continued)
P73162-A-F5U104-man.qxd 8/15/01 2:40 PM Page 17