Filter
Top Products
Operation36
Pro-Picture menu
Some picture adjustments are available only when certain input sources are in use.
Unavailable adjustments are not shown on the screen.
FUNCTION
(default setting/
value)
DESCRIPTION
Auto Resize
(On)
Automatically resizes the input signal pixel resolution to the native
resolution of the projector.
On: The pixel resolution of the input signal is converted to the native
resolution of the projector (800 x 600). For input signals with lower
resolutions, gaps in the pixels are automatically interpolated into the
picture before being projected. This may distort the picture clarity.
Off: The picture is projected as its original resolution, with no pixel
conversion. For input signals with lower resolutions, the projected picture
will display smaller than if resized to full screen. You could move the
projector towards the screen to increase the picture size if necessary. You
may also need to refocus the projector after moving the projector.
The projector is always started with the default setting of this
function and will not save and store the last change you make to it.
Aspect Ratio
(Native)
There are three options to set the picture's aspect ratio depending on your
input signal source.
See "Selecting the aspect ratio" on page 26 for details.
Keystone
(0)
Corrects any keystoning of the picture. See "Correcting keystone" on page
25 for details.
Horizontal
Position
(0)
Adjusts the horizontal position
of the projected picture.
Vertical
Position
(0)
Adjusts the vertical position of
the projected picture.
Phase
(depends on the
selected input
source)
Adjusts the video input clock to synchronize with
the video signal. This helps reduce picture
distortion produced by some PC video timings.
Horizontal
Size
(0)
Adjusts the horizontal width of the picture.
-30 +30
-30
+30