Filter
Top Products
Operation 47
English
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be sure
you have made a correct connection to the projector audio input. See
"Connection" on page
20
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
• Using the remote control
Press MUTE to temporarily turn off the sound. While the sound is off,
the screen will display in the upper right corner of the screen.
To restore the sound, press MUTE again.
• Using the OSD menu
1. Press MENU/EXIT and then press / until the SYSTEM
SETUP: Advanced menu is highlighted.
2. Press to highlight Audio Settings and press ENTER.
The Audio Settings page displays.
3. Highlight Mute and press / to select On.
4. To restore the sound, repeat steps 1-3 and press / to select Off.
Adjusting the sound level
To adjust the sound level,
1. Repeat steps 1-2 above.
2. Press to highlight Volume and press / to select a desired sound level.
Turning off the Power on/off ring tone
To adjust the sound level,
1. Repeat steps 1-2 above.
2. Press to highlight Power on/off ring tone and press / to select Off.
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power on/off ring tone.
INPUT SOUCER AUDIO IN
AUDIO
OUT
D-Sub-15
RGB mini jack mini jack
Component RCA RCA
DVI-A mini jack mini jack
DVI-D mini jack mini jack
HDMI HDMI HDMI
VIDEO RCA RCA
S-VIDEO RCA RCA