Filter
Top Products
Introduction 13
7. MODE
Depending upon which input signal is
selected, selects an available picture
setup mode. See "Application Mode"
on page 48 for details.
When a wireless module is installed
and the Wireless Connection menu is
displayed, press this button to change
among LAN, IEEE 802.11 a, and IEEE
802.11 b/g. (The wireless module is
available through BenQ retailers.)
8. BLANK
Used to hide the screen image. To
restore the image, press any button
(except LASER) on the projector or
remote control. See "Hiding the image"
on page 40 for details.
9. ENTER
Enacts the selected On-Screen Display
(OSD) menu item. See "Using the
menus" on page 46 for details.
10. Temperature warning light
Lights up red if the projector's
temperature becomes too high. See
"Indicators" on page 60 for details.
11. Lamp indicator light
Indicates the status of the lamp. Lights
up or flashes when the lamp has
developed a problem. See "Indicators"
on page 60 for details.
12. AUTO
Automatically determines the best
picture timings for the displayed
image. See "Auto-adjusting the image"
on page 35 for details.
When a wireless module is installed,
the Wireless Connection menu is
displayed and the IEEE 802.11 a is
selected, press this button to search for
a reliable channel. (The wireless
module is available through BenQ
retailers.)
13. SOURCE
Sequentially selects the input signal D-
Sub (Analog RGB), Comp. (YPbPr),
DVI-A, DVI-D, Video, or S-Video. See
"Switching input signal" on page 34 for
details.