Filter
Top Products
Operation 33
Entering the password recall procedure
Press and hold AUTO on the projector or remote
control for 3 seconds. The projector will display a
coded number on the screen. Write down the number
and turn off your projector. Seek help from the local
BenQ service center to decode the number. You may be
required to provide proof of purchase documentation
to verify that you are an authorized user of the
projector.
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security Settings >
Change Password menu.
2. Press ENTER. the message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
i. If the password is correct, another message 'INPUT NEW PASSWORD' displays.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for your
retry. You can either press MENU/BACK to cancel the change or try another
password.
3. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your
selected password down here in this manual in advance or right after the password
is entered so that it is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
4. Confirm the new password by re-entering the new password.
5. You have successfully assigned a new password to
the projector. Remember to enter the new
password next time the projector is started.
6. To leave the OSD menu, press MENU/BACK
twice.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced > Security
Settings > Password menu after opening the OSD menu system. Select Off by pressing
Left or Right. The message 'INPUT PASSWORD' displays. Enter the current
password.
i. If the password is correct, the OSD menu returns to the Security Settings page
with 'Off' shown in the row of Password. You will not have to enter the password
next time when turning on the projector.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You can
either press MENU/BACK to cancel the change or try another password.
Note that though the password function is disabled, you need to keep the old password in
hand should you ever need to re-activate the password function by entering the old
password.
Please write down the recall cod
e
and contact with the BenQ
Customer Center.
Recall code:
0 2 1 2
RECALL PASSWORD
Exit
Password Changed