Filter
Top Products
Operation 43
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu Display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last button press. The time length ranges
from 5 to 30 seconds in 5-second increments. Use Left/ Right to select a suitable
time.
• Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use Left/ Right to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On-
Screen (OSD) Menus. Use Left/ Right to select your language.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use Left/ Right to select a screen.
Shutting down the projector
1. Press Power and a confirmation
message will display prompting you.
If you don't respond in a few seconds,
the message will disappear.
2. Press Power a second time. The
Power indicator light flashes orange, the
projection lamp shuts down, and the
fans will continue to run for
approximately 90 seconds to cool down
the projector.
To protect the lamp, the projector will not respond to any commands during the cooling
process.
3. The Power indicator light is a steady orange once the cooling process has finished and
fans stop.
4. Disconnect the power cord from the wall
socket.
To save your time, you can unplug the projector as
soon as it is turned off without waiting for the cooling
time. The projector will continue cooling down even if
it is unplugged so that you can pack up the projector
and go. During the projector's off-line cooling, you
cannot restart it.
I
I
I
I