BenQ PE8700 Projector User Manual


 
4. Basic Operation
BenQ PE8700 User’s Manual
15
4. Basic Operation
Turning the Power on
Zoom/Focusing
The Power LED shines orange when power is
applied and the power switch is in the on position.
Press and hold the ON key on the remote control
or the STANDBY/ON key on the projector for
ONE second to turn the projector on. The
POWER LED will flash orange while warming up,
then show a steady green.
" Searching…." will be displayed on the screen
before the projector identifies the input signal. This
message will remain on the screen until a valid
signal is detected.
If the horizontal frequency of the input signal
exceeds the range of the projector (XGA), a
message reading " Not supportive timing " will be
displayed on the screen. This message will remain
on-screen until you change the input signal.
Adjust the projected image size you need with the
zoom ring on the lens. To focus the image, rotate the
focus ring on the lens.
Focus
Zoom in
Zoom out