Filter
Top Products
5. Menus
BenQ PE8700 User’s Manual
22
■ THROUGH : One-to-one mapping is performed without any scaling of the image, The image is displayed at the
center of the screen.
3. PC&HDTV: The following settings are only available with a PC or DTV RGB signal:
■ AUTO: Adjusts the phase, frequency and position automatically.
■ FREQ.: Adjusts the frequency of the input signal.
■ PHASE: Adjusts the phase of the input signal.
■ H. POS.: Adjusts the horizontal position of the image.
■ V. POS.: Adjusts the vertical position of image.
4. SAVE: There are three video memories in which the user can store settings, including all items in the Picture menu.
5. LOAD: Loads the settings from one of three video memories.
ENVIRONMENT Menu
In this menu, global settings for the projector can be made.
There are four items available: DEFAULT — LAMP TIMER — AUTO OFF — LAMP HOURS.
1. DEFAULT: Loads the default value of the current input source.
2. LAMP TIMER: Resets the lamp timer. This should only be done after the lamp has been replaced.
3. AUTO OFF: Sets the auto-shutdown timer. The timer can be set to a value between10 minutes and 3 hours.
4. LAMP HOURS: This displays the number of hours the lamp has been used. (The lifetime of the lamp is 2000 hours.)
If lamp usage exceeds 2000 hours, a warning message will be displayed on-screen; when this happens, contact your
BenQ dealer for a new lamp.
INSTALLATION Menu
This menu contains items necessary for installation.
Inactive area