Filter
Top Products
724-746-5500 | blackbox.com
Page 21
• dsl show errcntr help: Lists all the commands that start with dsl show errcntr
that the console recognizes.
2.6.2 System Configuration Commands
The following commands allow the user to configure the system:
• s
ystem set password <password>: Sets the system password (1-10 charac-
ters).
• s
ystem set circuitid <circuitid>: Sets the circuit ID (1-64 characters).
The following commands allow the user to view the current system configuration:
• s
ystem show config: Shows the configuration of the entire system, including
the DSL line.
Any changes to the system configuration or the DSL configuration will be lost on the
next power cycle unless the changes are saved. The command system save config
is used to save the changes.
2.6.3 System Status Commands
The following commands show system status:
• s
ystem show status: Shows the following system status information: LEDs,
DSL test mode, front panel switch settings, DSL link state, and configuration
mode.
2.6.4 DSL Configuration Commands
The following commands are used to configure the DSL:
• d
sl set timeslots <3-89>: Sets the DSL data rate. (The data rate is calculated by
the equation: data-rate = #timeslots x 64k.
• dsl set annex <a|b>: Set the annex.
• d
sl set lineprobe <enabled|disabled>: Enable or disable line probe.
• ds
l set mode <co|cpe>: Set the CPE as local (CO) or remote (CPE).