Filter
Top Products
Copyright 2006 Ringdale User Manual, 62-15820000 Page 12
1212
12 of
of of
of 49
4949
49
Configuration
The complete configuration can be done with any Telnet client, like HyperTerminal or
simply using the Windows Command prompt “telnet”. This will work on any
FaxReceiver that is on the same virtual network.
Black Box has provided a FaxConfig utility that allows you to perform the basic IP
configuration of any FaxReceiver that is on the same physical network.
These are the steps necessary to configure the FaxReceiver using the Windows
command prompt telnet client.
FAX CON FIGUR ATI ON UT ILIT Y
There is a FaxConfig utility on the CDROM in the Fax Configure Tool directory of
the CDROM. You can run this utility from the CDROM or drag it to your PC.
NOTE: The FaxConfig utility will only communicate properly with devices on its local
network or on 11.22.33.44.
1) Double-click on the FaxConfig utility to start it. It will bring up the following
screen:
2) If it does not see the FaxReceiver, check the connections and power, and then
click on the Requery Network button. If changes were made using Telnet,
you should click on the Requery Network button. If you have connected the
FaxReceiver since starting FaxConfig utility, use the Requery Network
button to discover it.