Filter
Top Products
Copyright 2006 Ringdale User Manual, 62-15820000 Page 19
1919
19 of
of of
of 49
4949
49
TEL NET SETT INGS
Select the TelNet tab.
1) Telnet port – This will enable the end user to set up a port that the
company does not block (e.g. port 80 or even port 25). That means that you
will be able to telnet into the FaxReceiver from your desk, enable debug, send
a fax to the unit (also from your desk), and figure out what is going wrong. If
you change the TELNET port number and don't reboot, the new number takes
effect on the *second* new telnet session. i.e. open telnet on default port
23. Change to port 1234 and do a quit/save. Open another telnet session,
still on port 23, and quit. All following telnet sessions must be on port 1234.
Session Time-out – This option allows you to keep your telnet session
active longer if you have a lot of interruptions while configuring the
FaxReceiver. If you specify zero as the Telnet session time-out, the session
will never time-out.
2) Click the OK button to exit the FaxDevice Configure for this device.
3) Click the Close button to exit FaxConfig utility.