Filter
Top Products
Copyright 2006 Ringdale User Manual, 62-15820000 Page 30
3030
30 of
of of
of 49
4949
49
P) Change Telnet password – If you do not change this, anyone can access
the unit and change the settings. Max 253 characters. For the telnet password, all
ASCII and non-ASCII characters may be used except control characters (those with
HEX codes below 0x20). Note however that some telnet clients will modify or not
pass non-ASCII characters, or may treat them as control commands for the telnet
program rather than passing them on, so best to stick with standard keyboard
letters, numbers and punctuation marks. Accented characters on non-English
keyboards may also be used without problem. Not required.
NOTE: passwords are case-sensitive. The FaxReceiver defaults to having no telnet
password (factory reset).
!) Redirect debug to this screen – This allows you to activate a troubleshooting
tool. When activated, telnet will not timeout. You can find more on this screen in the
troubleshooting section of this manual.
Q) Quit When you have completed your changes, press Q to Quit.
It will respond:
“Do you want to save your changes before quitting (Y/N)”
If you will enter Y it will save your parameters and report: “All changes saved.
Goodbye”. The Telnet connection will then be dropped.
If you will enter N it will not save your parameters and report: “Quitting WITHOUT
saving changes. Goodbye”. The Telnet connection will then be dropped.
NOTE: If you select n it will keep the parameters until the next power cycle or
reboot. This will allow you to test the new parameters before saving them.