8
REMOTE MANAGEMENT SWITCH
3. Installation
3.1 Master and Switched Ports
Connect the Remote Management Switch’s ports A through D found on the rear
of the unit to your RS-232 devices. Each port uses a DB25 subminiature connector
and supports the following leads for asynchronous communications.
Table 3-1. DB25 connector supported leads.
Pin Designation
2 Transmit Data
3 Receive Data
4 Request to Send
5 Clear to Send
6 Data Set Ready
7 Signal Ground
8 Data Carrier Detect
20 Data Terminal Ready
Figure 3-1. System diagram.
Remote
Management
Switch