14
REMOTE MANAGEMENT SWITCH
At this point, the master port is connected through to the port selected. The
Remote Management Switch is passive to the messages sent between the master
port and the port selected. To terminate the session with the current port and
bring back the menu, enter the escape character plus the security code and
another escape character (for example: <Esc>TEST<Esc>).
4.2.2 P
OWER
C
ONTROL
This selection allows control of the outlets in the Remote Management Switch.
Figure 4-3. Controlling outlets.
Again, you can name each relay. Eng (Energized or ON) and Den (De-energized,
or OFF) display the current status of the relay. To toggle the relay, simply enter the
relay number, followed by Enter.
The outlet can also be cycled (pulsed) by entering P plus the number (for
example, P1 to cycle relay number 1). The length of time the outlet pulses is preset
through the programming menu. While the relay is cycling, a cycling message will
be displayed as shown in Figure 4-4.
Figure 4-4. Cycling.
1) Den Outlet 1=>cycling
2) Eng Outlet 2
3) Den Outlet 3
4) Eng Outlet 4
# - Select relay to toggle
P# - Pulse relay
X - Exit
Enter >
1) Eng Outlet 1
2) Eng Outlet 2
3) Den Outlet 3
4) Eng Outlet 4
# - Select relay to toggle
P# - Pulse relay
X - Exit
Enter >