Filter
Top Products
66
Modem 34336
NOTE
Passwords may be stored only in memory locations 2 through 9.
5.Programming a response to a correct password. Enter the following
command, replacing CONNECTED with your message:
AT &Z0=/UCONNECTED
The DTE responds with the specified message when the modem receives
a correct password.
NOTE
The /U command and message can be stored only in memory location 0.
4.8 Modem-Controlled Remote Control
Certain modems can be used to remotely control other modems. Alternately,
modems may be remotely controlled from a computer or other DTE. This
section explains modem-controlled remote control. Remote control from a
DTE is explained in Section 4.9.
Two types of modem-controlled remote control are possible:
• Direct modem-to-modem control—One modem can be used to control
the front panel of another modem through a phone link.
• Control through a rack controller—A modem in a rack enclosure equipped
with an intelligent rack controller can control:
Another modem in the same rack or
A remote modem connected to any modem in the rack.
For both types of remote control, the controlling modem and the controlled
(remote) modem must be connected at a data rate that uses trellis coding.
(This does not apply, however, if both modems are installed in the same rack
and the rack is equipped with a rack controller.)
4.8.1 D
IRECT
M
ODEM
-
TO
-M
ODEM
R
EMOTE
C
ONTROL
REMOTE screen 1 on the LCD allows you to use one Modem 34336 to
control the front panel of another Modem 34336 via a phone link. (REMOTE
screen 2 is discussed in Section 4.8.2.)