Filter
Top Products
724-746-5500 | blackbox.com Page 25
Chapter 6: Operation
Figure 6-9. Testing progress is shown on the screen.
Figure 6-10. Any problems will be displayed (see Appendix C).
During this phase of testing, information about length, opens,
shorts, split pairs, crosstalk, cable category, and speed is being
gathered and computed. If there are no cable problems, testing
continues until you are prompted to connect the Remote Probe
and perform a wire map test. If all is OK, testing will finish (the
“speed” screen is displayed).
NOTE: If there is a problem with the cable, the problem will be
displayed, and testing will be halted. The problem must
be corrected before testing can continue. See Appendix C
for examples of cable failures.
Complete results are immediately available for Review and
Saving after the test is completed. This “test now, review later”
feature greatly speeds up the test process when you have
multiple cable installations.