Filter
Top Products
6 en | Door Profile Access Control Interface Module
F.01U.201.526 | 02 | 2011.10 Program Entry Guide Bosch Security Systems, Inc.
1-8 This CC# Scope determines disarming rights. The user’s access level in conjunction with
the CC # Scope will determine which areas will be disarmed.
Blank Only the area assigned to the D# Entry Area will disarm for this door.
Enter the point number that will be assigned to this door. This point cannot be used for any
other point assignments.
1-127, 129-247 The point number assigned to this door. Points 128 and 248 are reserved by
the panel for internal use.
Blank There is no point number assigned to this door.
Enter the interlock point number. This point, when faulted, will prevent the door controller
from allowing access upon a valid ID read or door request.
Do not assign this point as a door point to another door point. You may assign it to another
controller thereby having one interlock point prevent multiple controllers from activating.
1-127, 129-247 The point number assigned to this door. Points 128 and 248 are reserved by
the panel for internal use.
Blank There is no point number assigned to this door.
D# Door Point
Default: Blank
Selections: Blank, 1-127, 129-247
NOTICE!
Door Points must be programmed as Perimeter Points. If a 24 hour point type is required for
the Door Point, you may use a Perimeter Point Type with a Point Response of 9 - C. Also, the
Debounce Count must be set to 4 in Point Assignments.
NOTICE!
When assigning points 1to 8 (panel zones), the end of line resistors must be removed from the
panel
NOTICE!
Do not enable any POPIT points (or OctoPOPIT points) sharing the same point number as the
Door Point. Failure to do so will result in Extra Point trouble conditions upon reboot.
D# Interlock Point
Default: Blank
Selections: Blank, 1-127, 129-247
NOTICE!
The interlock point will be considered in a normal state if it is bypassed swinger bypassed or
forced armed. This will result in normal operation of access even if the door is left open.