Filter
Top Products
18 en | Navigating the Monitor General Purpose LCD Monitors
F.01U.127.338 | 2.0 | 2009.05 User’s Manual Bosch Security Systems, Inc.
7.2 Navigating the Monitor On-screen Display (OSD)
The UML-151-90, UML-171-90, and the UML-191-90 have two (2) modes: Video and VGA. The
LCD is programmed through the on-screen display (OSD) menus and submenus where an
operator can select operating parameters. To access the OSD menus, press the Menu button.
Use the front panel of the monitor to make any necessary adjustments to the OSD.
To navigate the set up menus, follow the steps below:
1. Connect the CVBS or VGA cable.
2. Press the Power button to turn on the unit (see Figure 7.1).
3. If required, press the Input button to select the appropriate signal.
4. Press the Menu button to activate the main menu selections (see Figure 7.1).
5. Press the and the buttons to select a menu.
6. Press the Input button to enter the selected menu.
7. Press the and the button to toggle the OSD values.
8. When finished, scroll to Exit and press the Menu button. Note: If there is no Exit button,
press the Menu button.