Filter
Top Products
Getting Started
Assigning an IP Address
40
Y885775 BradyConnect 10/100 Internal Print Server User Guide 07/18/2008
Assigning an IP Address
Before you can begin working with 10/100 Internal PS, you must get or assign an IP address
for the 10/100 Internal PS device.
There are three different ways to assign an IP address. Here is a list and a brief description of
each method:
• Web View — Browser-enabled method to assign an IP address.
• DHCP — See your LAN administrator for more information.
• Telnet — DOS command to assign an IP address.
With Dynamic Host Configuration Protocol (DHCP)
If your network uses DHCP, your 10/100 Internal PS device is assigned a temporary IP
address.
Without DHCP
If your network does not use a dynamic IP addressing system (such as DHCP), you need to set
a permanent IP address for the 10/100 Internal PS device.
Important • Throughout the procedures in this chapter, there are some features that require the
default User ID and/or default password. If you are prompted, these are the defaults:
• User ID: admin
• Password: 1234
Note • Check with your Network Administrator to see whether your network uses DHCP.