Filter
Top Products
85
Hardware Troubleshooting
Troubleshooting the 10/100 PS
07/18/2008 BradyConnect 10/100 Internal Print Server User Guide Y885775
Telnet
Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be
used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to
cause a label to print.
To open a telnet session on your PC, complete these steps:
1. Open a DOS window.
To open a DOS window, click on
Start > Run.
2. In the Open text box, type: cmd
3. From the DOS prompt, type:
telnet xxx.xxx.xxx.xxx 9100
where xxx.xxx.xxx.xxx is the IP address of the print server.
This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.
4. Enter ~WC.
This ZPL command will print a configuration label on your printer.
5. Click the X in the upper right-hand corner of the window to exit.
If the configuration label prints, the issue is not a communication problem between the printer,
the print server, or the PC.
Note • You do not need to open a telnet session if you pinged the printer using the previous
procedure. The purpose of these two procedures is to identify whether your PC can
communicate with your printer.